P a g e
5 | 10
A.
Cut out a hole in the ceiling where the ducting
will go.
B.
Prepare support framework for ceiling
bracket.
C.
Place chimney bracket against ceiling & screw
it into place.
D.
Drop the ducting and electrical work through
the ceiling.
STEP #3: INSTALLING “SUPPORT BRACKET”
STEP #4: ATTACHING HOOD BODY
HINT:
Due to the heavy weight of this range hood, use of a vertical jack to lift and support the hood in place is highly recommended.
STEP #5: INSTALLING CHIMNEYS
- DO NOT REMOVE CHIMNEY PROTECTIVE FILM UNTIL FINISHED INSTALLATION
Slide upper “hook”
chimney (UHC) in,
leave about 1” from
(
the ceiling. Use
tape to hold it up
from falling down if
you don’t have any
helper to hold it.
Slide the entire
chimney up and
secure with the
ceiling bracket
using the 2
provided bolts
– 1 on each
side.
9. INSTALLATION
STEP #2: INSTALLING “CEILING BRACKET”
CAREFULLY
REMOVE
CHIMNEY
PROTECTIVE
FILM.
Slide upper
“slot” chimney
USC) into place
connecting the
6 “C” locks – 3
on each side.
STEP #1: MARKING “CEILING BRACKET”
A.
Put a thick, protective covering over counter top, cook top or
Range to protect from damage or debris.
B.
Find and mark the center point directly above your cook top.
C.
Place the ceiling bracket on the ceiling around the center point.
Make sure it is square with your cook top).
D.
Trace the outline of the ceiling bracket onto the ceiling.
E.
Trace a circle where the ducting will go.
F.
Mark the 4 pre-holes where you will insert the screws.
IMPORTANT
Before
moving to STEP5, do the following:
1.
Make sure the damper is able to open
FULLY when the hood is on.
2.
Test run to see if there is any air leaks
/ abnormal noise.
D.
Have a third person raise up the
island range hood into its position.
Hood should be directly under the
support brackets.
E.
Attach the hood to the support
brackets at all 4 corners with bolts.
F.
Connect the ductwork to the range
hood. Use aluminum tape to secure
the pipe joint area.
G.
Connect power plug.
Set the lower
“HOOK”
Chimney piece
into place so
it drops into
the top of the
hood.
Carefully slide
and drop
lower “SLOT”
chimney into
place. Make
sure SLOT and
HOOK are
snapped.