REPLACING THE LIGHT BULB
1.
Make sure the range hood is unplugged or turn OFF
breaker.
2. Use the small flat crew driver to lift any where
around the outsider ring as show in below picture
Arrow.
3. Install new light bulb
4. Put back the light set by press it in.
5. Turn ON breaker and range hood to test for
operation.
TROUBLE SHOOTING
1. If the range hood or lights do not
operate after installation:
2. The range hood vibrates when the
blower is on:
3. The blower or fan seems weak:
4. The lights work but the blower is not
spinning at all, is stuck or is rattling.
5. The hood is not venting out properly:
6. The hood is noisy than normal
7. Control panel is not active
8. Remote control is not working
•
Check if the range hood has been plugged in, make sure that all
power has been turned back ON, the fuse is not blown and all
electrical wiring is properly connected.
•
Swap out light assembly to working ones to determine whether it is
caused by defective bulbs. See
replacing the light bulbs
on Page
10.
•
The range hood might not have been secured properly on to the
ceiling.
•
Check if the motor is secured in place. If not, then tighten the
motor in place.
•
Check if the blower wheel is a damaged.
•
Check that the duct sized used is at least 6”. Range hood WILL
NOT function efficiently with insufficient duct size & loosely
secured.
•
Check if duct is clogged or if damper unit (half-circular flapper) is
not installed correctly or opening properly. A tight mesh on a side
wall cap unit might also cause restriction to the air flow.
•
The blower might be jammed or scraping the bottom due to
shipping damage. Please contact us immediately.
•
The motor is defective, possibly seized - change the motor.
•
Electronic board might have errors
•
Make sure the distance between the stove top and the bottom of the
hood is within 26” and 30” in distance.
Due to different ceiling
height configurations, recommended height may not be applicable.
•
Reduce the number of elbows and length of duct work. Check if all
joints are properly connected, sealed, and taped.
•
Make sure the power is on high speed for heavy cooking
•
The duct is not secure cause variation
•
The wrong duct size is using
•
Check to make sure the auto function is not on
•
Check to make sure the plastic film was removed.
www.XtremeAirUsa.com
PAGE
11
