Xtreme XR1255, Operation Manual

Page: 74 / 80

Page 72
Xtreme Manufacturing, LLC
Preventive Maintenance XR1255
Boom Emergency Lower Down Valve
Both of the lift and extend cylinders are equipped with a
needle valve which allows the cylinder to retract without
the direct assist of the machine hydraulic power This
feature is intended to be used only in the event of total
loss of engine or hydraulic pump failure with an elevated
boom
In any event, the vehicle should be secured until the
situation has been properly evaluated Secure the vehicle
and area by following the procedures below:
1.
Clear the area around the vehicle of all personnel
2.
Place the shift lever in ‘Neutral’ and engage the
parking brake switch to the on position
3. Section off a large area under the boom with tape to
restrict any personnel from entering this potentially
dangerous area
4. If the load is in a position where it can be removed
safely, completely remove the load from the carriage
and/or attachment; otherwise leave the load in place
5.
Remove boom access cover on back of boom
6.
Locate needle valve on extend cylinder Loosen nut
on valve, then loosen valve with hex wrench
7. Fully retract boom with control handle in cab
8. When boom is fully retracted, tighten valve with hex
wrench, then tighten nut to secure valve
9.
Locate needle valves on lift cylinders Loosen nut on
valve, then loosen valve with hex wrench (repeat for
both sides)
10.
Fully lower boom with control handle in cab
11. When boom is fully lowered, tighten valve with hex
wrench, then tighten nut to secure valve (repeat for
both sides)
Figure 8-2. Boom Access Cover.
Figure 8-3. Extend Cylinder Lower Down Valve.
Figure 8-4. Lift Cylinder Lower Down Valve.
Do Not Operate – Accident Prevention Tags
Before beginning any maintenance or service, place a Do
Not Operate Tag on both the starter key switch and the
steering wheel, stating that the vehicle should not be
operated Do Not Operate Tags, which can be cut out and
used, are included at the end of this manual Retain these
Tags for reuse at a later date
New or Additional Operators
At the time of original purchase, the purchaser of this
vehicle was instructed by the seller on its proper use If
this vehicle is to be used by an employee or is loaned or
rented to someone other than the purchaser, make certain
that the new operator is trained, in accordance with OSHA
regulations, and reads and understands this Operation &
Safety Manual before operating the vehicle
In addition, make sure that the new operator has
completed a walk-around inspection of the vehicle,
is familiar with all Labels on the vehicle, and has
demonstrated the correct use of all controls