8
OPERATION
Generator Oil Alarm:
The generator oil alarm is designed to alarm the user the fact that the generator oil
in the crankcase in insufficient. Run with insufficient generator oil may damage the generator. Once oil level
in the crankcase is too low, the generator oil alarm will stall the generator automatically to make it free of
damage while the generator switch is still at “ON”.
CAUTION:
If the generator still fails to work, check the generator oil level first before go to other check items.
Breaker (Electric Start):
The Breaker is used to protect the battery
charging circuit. It will be disconnection when short circuit or battery
polarity connects in wrong direction. Check items.
The green indicator would be light once the circuit off. If this happens,
please find out the reason and solve it then press the button to recover
the breaker.
In higher elevations, the standard mixture ratio is relatively too big so the generator performance may be
impaired while the fuel consumption may increase. This problem can be solved as follows: replace the main
jet of carburetor with a smaller one, then, adjust the idly screw. If always using on highlands with a height
above sea level of 1830 meters, ask your dealer for doing the job. The generator power will decrease by
about 3.5% with every 305 meters up in height; even the proper main jet is used. The output would be much
lower if not adjust the jet.
CAUTION:
The generator equipped with the main jet applicable to high altitudes may be damaged seriously
in area below specified altitude, because its mixture ratio is too thin, output drops and the generator overheats
for operation in low altitude area. In the case, ask your dealer to recover the generator to its normal technical
status.
STOPPING THE GENERATOR
1.
Push right the throttle valve
lever to the bottom
2.
Push the generator switch to
“OFF”
3.
Set the fuel switch to “OFF”
With the generator running, carbon monoxide, oxide of nitrogen and hydrocarbon will produce, and in certain
conditions, oxide of nitrogen and hydrocarbon will react chemically each other to make smoke while carbon
monoxide is toxic, so exhaust control of them is very important. The company decreases the exhaust emissions
by introducing poor-fuel carburetors and other devices into the generator to solve the problem.
EXHAUST CONTROL SYSTEM
Maintain the generator periodically in accordance with the Maintenance Schedule in the manual. The
maintenance schedule is made out on the base of normal use in normal conditions, if using under heavy load,
dusty or wet circumstances or in high temperature, more frequents maintenance will be necessary.
We recommend that you should choose such parts, which are manufactured by XTREMEPOWERUS or
equivalent to these in quality as replacement ones. Replacement without so high quality may impair the
exhaust control system in effectiveness.
Summary of Contents for 65038
