PAGE
7
STEP 7: INSTALLING CHIMNEYS
-
DO NOT REMOVE INNER CHIMNEY PROTECTIVE FILM UNTIL FINISHED INSTALLATION
1
OIL TUNNEL: Drop oil tunnel into recess
support near rear of hood.
Note: PX04 & PX06- skip this step
STEP 6: SECURE THE HOOD BODY & TEST RUN
A.
Use a stud finder to find all studs below the hood body. Put blue tape on every stud
found.
B.
Use 1/8” drill bit to drill though the back of hood in line with blue tape.
C.
Secure the hood body by using the 2.0 inches wood screws (provided) through the
back of hood to the stud.
D.
Refer to page 8, Range Hood Operation. Try a few test runs to ensure machine is
running properly.
STEP 6A: FOR PX01
& SU01
MODEL ONLY
– INSTALL GLASS CANOPY
A.
Loosen the four canopy screws and washers from the hood top.
B.
Carefully place the canopy glass on the hood top then slightly tighten the four
canopy screws along with washers. DO NOT put excessive pressure against the
glass.
10. BAF LE FILTERS INSTALL & REMOVA
IMPORTAN :
FOR THOSE MODELS THAT HAVE MORE THAN 2 BAFFLE FILTERS, ALWAYS INSTALL THE MID
D
LE FILTER LAST WHEREAS REMOVE IT FIRST IF YOU ARE TR
Y
ING
TO REMOVE ALL OTHER FIL
T
ERS.
Angle baffle filter
toward back of
hood
2. Lift a baffle filter up above horizontal level
then slide forward into slot behind the front of
hood. To remove, please reverse the process
Install & Remove Baffle Filters
A.
Remove outter chimney
protective film (not the
inner chimney).
B.
Place both chimneys on
top of range hood base.
C.
Secure outside chimney
to the base of the hood
(PX02
/ UL02/ PX15
ONLY).
A. Lift up and attach the
innner chimney to the
ceiling mounting
bracket.
B. Screw the chimney into
place on both sides.
C. Remove inner chimney
protective film.
Summary of Contents for SU01-W30
Page 8: ......
