Xtream HK400FW, Operation Manual

Page: 12 / 26

12
assembly
Assembly
COMPONENTS
ASSEMBlING FRAME AND WHEElS
0 Kerosene Portable Heater Manual
CoMPonenTs
PORTAblE hEATER SPECIFICATIONS
Model Mh-0400-0M10
Rating bTU/hr 400,000
fuel Consumption
Gal/hr
3.0
fuel Tank Capac-
ity Gallons 24.0
Pump Pressure
PsI 25
volt/hz
20V/ 60 Hz
amps
3.0
Phase
Single
size (l x W x h) 53" x 30" x 36"
net Weight (lbs) 50
Wheels
(Pheumatic)
Wheel Caps
(black Rubber)
Screws (L) Flat Washers (S) Flat Washers (L)
Bushings Cottern PIns
Cord Wraps
Screws (S)
Nuts
Front Handle
Wheel Support Frame
Axle
Rear Handle
ASSEMblY
1. Slide axle through wheel support frame. Install wheel bushings, flat
washers (S) and wheel on axle. NOTE: When installing wheels, tube
valve should face out from support frame.
2. Place flat washers (L) and cotter pins on axle ends and bend cotter
pins with long nose pliers to secure.
3. Place wheel cap on flat washers (L) and put wheel cap in flat washers
(L) end.
4. Place heater on wheel support frame. Make sure air inlet end (rear) of
heater is over wheels. Align the holes on fuel tank flange. Insert screws
through handles (front and rear), fuel tank flange, and wheel support
frame as shown in below and attach nut finger tight after each screw is
inserted.
5. After all screws are inserted, tighten nuts firmly.
Kerosene Portable Heater Manual
Note: Tools required: medium phillips screw driver, open end or adjustable wrench, long nose pliers.
asseMblInG fRaMe anD Wheels
1. Slide axle through wheel support frame. Install wheel bushings, flat washers (S) and wheel on axle.
NOTE: When installing wheels, tube valve should face out from support frame.
2. Place flat washers (L) and cotter pins on axle ends and bend cotter pins with long nose pliers to secur e.
3. Place wheel cap on flat washers (L) and put wheel cap in flat washers (L) end.
4. Place heater on wheel support frame. Make sure air inlet end (rear) of heater is over wheels. Align the holes
on fuel tank flange. Insert screws through handles (front and rear), fuel tank flange, and wheel support frame
as shown in below and attach nut finger tight after each screw is inserted.
5. After all screws are inserted, tighten nuts firmly.
Do noT oPeRaTe heaTeR WIThoUT sUPPoRT fRaMe fUllY asseMbleD To TanK.
ASSEMblY
Nut
Wheel Support Frame
Wheel Tube Valve
Fuel Tank Flange
Air lnlet
Cord wrap
Screw (L)
Screw (S)
Axle
Safety Guard
Wheel (Semi-pneumatic)
Bushing
Flat Washer (L)
Flat Washer (S)
WheelCap
Cotter Pin
WARNING
• DO NOT OPERATE HEATER WITHOUT SUPPORT FRAME FULLY
ASSEMBLED TO TANK.