Xtralis VESDA VLC-505, Manual

Page: 309 / 367

VESDA by Xtralis VESDA Pipe Network Installation Guide
www.xtralis.com 11
3.11 Labels
Sampling point labels – There are two labels to identify sampling holes:
l
Miniature sampling point label: These are round labels with a hole in the center to fit around the
miniature sampling points. Refer to Figure 3-10.
l
Sampling point decal: This decal is wrapped around a pipe on the sampling hole. The decal has a
hole in the center. The hole in the decal must be aligned to the sampling hole drilled into the pipe. Refer
to Figure 3-11.
l
Pipe label: This label identifies the pipe as being a smoke detector pipe and warns against tampering
with it. Refer to Figure 3-12.
l
Test Point label: This label identifies a sampling point which is used for test purposes. It is normally
the last sampling point on the main pipe or branch pipe. Refer to Figure 3-13.
V
ES
DA
®
FIR
E
D
E
T
E
C
T
IO
N
S Y
S TE
M-
D O
N
O
T
P
A
IN
T
Figure 3-10: Miniature Sampling Point label
FIRE
DETECTION
SYSTEM
DO NOT
P
AINT
FIRE
DETECTION
SYSTEM
DO NOT
P
AINT
Figure 3-11: Sampling Point decal
CAUTION CAUTION CAUTION
VESDA SMOKE DETECTOR SAMPLING PIPE
DO NOT REMOVE, PAINT OR OBSTRUCT
Figure 3-12: Pipe label
www.xtralis.com
part no. 29624
Install Date:
Detector Zn #:
Pipe #:
Test Point #:
Transport Time (sec):
Suction Pressure (Pa):
document no. 18715
TM
TM
TM
TM
Figure 3-13: Test Point label