ADPRO
XO I/O Interface USB Module – Technical Manual
32688_02
7
1
About the XO I/O Interface USB Module
Note
You can find the latest versions of this document and any referenced document on the Xtralis Security
Solutions Support site
(logon may be required). If a document number is
indicated (between parentheses), you can enter it in the Keywords box on the site, and search for the
document.
1.1
Features
The XO I/O Interface USB modules contain sets of Main I/O and Extension I/O cards (Next Generation) that you
can connect to your XO device via USB for extra inputs and outputs. You do not need to build the cards into the
device itself.
The following models exist:
l
Single module. Contains one set of I/O cards: one Main I/O (MIO) and one Extension I/O (EIO) card.
l
Double module. Contains two sets of I/O cards: 2 x (MIO + EIO).
XO I/O Interface USB module:
Rear view, single module:
Rear view, double module:
The modules offer:
l
Extra inputs and outputs:
o
Single module: 20 tamper-protected inputs and 8 relay outputs (rated 14 VDC @ 1 A)
o
Double module: 40 tamper-protected inputs and 16 relay outputs (rated 14 VDC @ 1 A)
l
GND for every input
l
The inputs are 4-state balanced inputs. The possible states are:
o
normal open
o
normal closed
o
tamper short circuit
o
tamper open circuit
l
For FastTrace 2 Series only: driver for analogue PTZ cameras on the MIO card (2-wire half duplex RS-485)
l
Driver for VM22E audio switcher on the MIO card
l
Front LED indicators.
