Unload TS100 tire pressure sensor
Install TS100 tire pressure sensor and cycle valve
3
Attention: cycle valve and margin
opening should be concentric.
4
Step 1. Tighten the screws to connect the cycle valve and
sensor subject firmly. Paint grease or lubricating oil on rubber
valve rod.
Step 2. Insert the valve rod into valve opening from rim interior,
and connect a standard valve cycle extractor to the end of valve
rod.
Step 3. Pull the valve rod to stuck on the valve opening firmly,
then assemble the bonnet back on valve rod.
Step 1
Screw out the screw at the end of rubber valve
rod, fetch the sensor subject carefully. Carve up
rubber snap joint and connect a standard cycle
valve extractor to rubber valve, according to pull
the margin to unload cycle valve from valve clack.
