XTline XT106005, Manual

Page: 24 / 25

Drilling depth control
The drilling depth may be adjusted by the drill stop which can be easily
inserted into the holder on the tool grip by depressing and holding the switch
and inserting into the groove. Set the drill stop to the requested drilling depth.
Work mode
Do not set the work mode while operating the tool!
Choose the work mode by rotating the switch to the requested position.
Impact drilling - Drilling - Cutting position Cutting
concrete and stone wood, tightening setup
The direction of rotation
Do not change the direction of rotation until the tool stops completely. If not
respected, it may cause damage.
Maintenance
Clean the machine and lubricate the tools regularly.
Check for screw tightening regularly.
Check the power cord regularly.
6. General safety instructions
Electric safety
a) The power cord plug shall always suit the socket. Never adjust the
socket. Do not use plug hubs. Non-adjusted plugs and appropriate
sockets reduce the risk of electric shock injury.
b) Prevent body contact with conductive surfaces to avoid a risk of electric
shock injury.
c) Do not expose the tool to rain or wet locations. Presence of water in
electric tool highly increases the risk of electric shock injury.
d) Do not force the cord. Keep the cord away from heat sources, oil, sharp