d)
When not in use, idle tools should be stored in a place out of reach of visitors and children.
e)
Maintain careful manipulation with the tool. Check for deflecting or jamming of turning parts, damaged
parts or other conditions which may influence operating with the tool.
f)
Keep tools sharp and clean for better and safer performance. Properly serviced tools are less likely to
become covered in impurities and are better controlled.
g)
Use equipment recommended by the producer of your model only. Modifications and accessories used at
one tool may be dangerous when used with another model.
Warranty does not apply for accessories!
USING
VARIABLE SPEED TRIGGER - FIG. 6
When trigger 2 is depressed, the drive will rotate (provided the direction switch 7 is
set in the forward or reverse position).
This trigger switch is electronic which enables the user to vary the speed continously.
- The speed varles according to how far the trigger switch is depressed
- The further it is depressed, the fastor the drive spindle will rotate
- The lighter it is depressed, the slower it will rotate.
Note: if the fastening is heavily corroded, or estremely tight, it may be necessary to
release the fixing by hand before continuing with the driver.
Note: This product is equipeed with an aelctric brake.
BELT CLIP - FIG.7
The spring steel belt clip 7 is convenient for hanging the drill temporarilly. The clip
can be installed on either side of the tool.
To install the clip:
Locate the dip 6 in position and fasten with screw 6.1 supplied, take care to not
overtighten and stri the thread.
LED WORKLIGHT - FIG.8
To aid use in confined and inadequately lit spaces, the LED worklight 4 autotically
illuminates when the trigger is activated.
INSTALLING AND REMOVING BITS - FIG.4
This driver is supplied with a 1/4" female hex.
Pull and hold the quick release collet 1 outwards to insert and to release the bit.
Note: This product is equipped with an electric brake. Never use any bits or
accessories that are not hardened for impact use.
ROTATIONAL DRIVE SELECTION - FIG. 5
The forward/reverse drive selector switch 7 determines the direction of rotation of
the drive, i.e. clockwise or anticlockwise.
to alter the direction of rotation:
- Stop the machine and push switch 7 to the left or right.
- When the direction switch is pushed to the left, the drive will rotate clockwise.
- When the switch is pushed to the right, the drive will rotate anticlockwise.
- Before operation, check that the switch is set in the required position, Do not
change the direction of ratation until the driver comes to a complete stop.
- When the driver is not in use move the direction switch to the neutral position (the
middle setting) to lock the trigger out.
Note: Falue to use the neutral position may activate the trigger inadvetently. This
inadvetent operation may cause the driver to become damaged.
Disposal
At the end of the machine´s working life, or when it acan no longer be repaired, ensure that it is disposed of
according to national regulations.
