shock injury.
e)
When manipulating in exterior areas consider an extension cord
intended for outdoor use specifically. Using an exterior extension cord
decreases a risk of electric shock injury.
f)
It is strictly recommended to use a ground fault circuit interrupter (GFCI)
when manipulating the tool in a wet area. Using of GFCI decreases a
risk of electric shock injury.
g)
A double insulated tool is equipped with a polarized plug (one prong is
wider than the other). If the connector does not fully suit the socket, turn
the plug. Do not change the plug by any means. Double insulation
eliminates the need for grounding of power cord and power supply
system.
Personal safety
a)
Stay alert and do not use the tool when under influence of alcohol.
b)
Use safety glasses and face or dust mask. Wear protective hearing
equipment, helmet and boots.
c)
Avoid unintentional starting. Before connecting to power source or
battery, make sure the switch is at OFF position.
d)
Dress properly. Do not wear loose clothing or jewelry. They can be
caught with moving parts.
e)
Remove adjusting keys and wrenches
.
Tool or adjusting key you leave
attached to a turning part of the tool may cause injury.
f)
Do not overreach. Proper footing and balance at all times allow better
control of the tool in unexpected situations.
g)
Use approved protective equipment only.
Electric tool handling and maintenance
a)
Do not force the tool.
b)
Do not use if the ON/OFF switch does not work properly.
c)
Disconnect the plug from socket and/or battery from the tool prior any
adjustment, accessory replacement or storage of tool. These
preventive safety precautions reduce a risk of accidental starting of tool.
d)
When not in use, idle tools should be stored in a place out of reach of
visitors and children.
e)
Maintain careful manipulation with the tool. Check for deflecting or
jamming of turning parts, damaged parts or other conditions which
may influence operating with the tool.
f)
Keep tools sharp and clean for better and safer performance. Properly
serviced tools are less likely to become covered in impurities and are
better controlled.
g)
Use equipment recommended by the producer of your model only.
Modifications and accessories used at one tool may be dangerous
when used with another model.
Summary of Contents for M1W-TD-115E2
Page 11: ...Rozkres ...
Page 13: ......
