Xterra FS3.9e, Owner'S Manual

Page: 8 / 21

7
ASSEMBLY INSTRUCTIONS
1
CONSOLE MAST ASSEMBLY
1. Locate the Console Mast (10) and Console Mast Cover (41) and slide the Cover onto
the Mast as far as it will go. Make sure the Console Mast Cover (41) is facing the
correct way.
2. At the top opening of the Main Frame (1) of the elliptical is a Computer Cable (32).
Unravel and straighten out the Computer Cable (32) and feed it into the bottom of the
console mast tube (10) and out of the top opening.
3. Install the Console Mast (10) into the receiving bracket in the top of the Main Frame (1).
Put the 4pcs of 5/16"x 23 x1.5T Flat Washers (97) onto the 4pcs of 5/16" x 15m/m Hex
Head Bolts (70) and the 2pcs of 5/16" x 23 x 2T Curved Washers (102) onto the 2pcs of
5/16" x 15m/m Hex Head Bolts (70). Install, and hand tighten by using the 12m/m
Wrench (110).
NOTE: There is a electrical wire running through the Console Mast Tube (10). Be
careful not to damage or pinch this Computer Cable (32) during this procedure.
4. Locate the Console Assembly (31) and the 4pcs of M5 x 10m/m Phillips Head Screws
(78) by using the Combination M5 Allen Wrench & Phillips Head Screw Driver (108).
5. There will be three electrical wire connectors at the top opening of the Console Mast
(10), two Handpulse W/Cable Assemblies (37~3), one Computer Cable (32). Connect
these to the mating connectors on the back of the Console Assembly (31). The
connectors are keyed so you cannot plug them in the wrong way so do not force them.
6. Storing the excess wire back into the Console Mast (10), carefully install the Console
Assembly (31) onto the mounting plate of Console Mast (10) and secure using the 4pcs
of M5 x 10m/m Phillips Head Screws (78).