Customer Service 1-888-707-1880
or email [email protected] Dyaco Canada Inc. ©2014
8
STEP 3
Remove the clamp (25) and allen screw (22) from the upright (4). Attach the handlebar (5) to the
front of the upright (4) using the clamp (25). Finger tighten the allen screw (22) to the top of the
clamp (25). Attach the plastic cover (37) over the clamp using the t-type knob (21).
Connect the extension wire (33) to the wire from the back of the monitor (6).
Connect the handpulse wires (20) to the wires from the back of the monitor (6).
Attach the monitor to the bracket of the upright (4). Secure using the four screws (27) which are
pre-assembled on the back of the monitor
Tip: Avoid pinching the Extension Wire
21
22
25
37
20
32
33
4
6
27
27
5
STEP 4
Orient the seat (8) and the seat post (7) as shown.
Attach towel rack (36) to the sliding tube under the seat (8). Secure using the two flat washers
(12), two spring washers (13) and two nylon nut (14) which are pre-assembled on the seat.
Slide the seat (8) on to sliding tube of the seat post (7) and secure with one carriage bolt (47),
one square plate (48), one small bushing (49) and the seat adjustment knob (19).
Insert the seat post (7) into main frame (1) through the cover for seat post (17). Tighten with quick
release knob
.
1
17
11
47
48
49
7
8
12
13
14
36
19
