the system will automatically execute the Auto Rebuilding function with out affecting the system
operation and without any operation command from the user.
3
. The LCD Display Message During Hot Swap and Auto Rebuilding When the
XL-RAID-213SA
detects a hard drive missing or a hard drive failure, the Buzzer will go off and the LCD display
screen will display the following messages:
4.
After removing the failed hard drive and replacing with a new hard drive, if the hard drive is
properly installed, the LCD display screen will display the following messages:
5.
After few seconds of installing the new hard drive, the LCD display screen will display the data
rebuilding progress:
Pri->Sec represents that the data in the original hard drive (primary hard drive) is copied to the
new hard drive (secondary hard drive). XXX % represents the rebuilding completion percentage.
6.
When the rebuilding is fully completed, the LCD display screen will again display the following
messages:
7.
When
XL-RAID-213SA
is overheating,
“T”
will be displayed on the lower right-hand cor ner of
screen (As shown in illustration)
Summary of Contents for XL-RAID-213SA
Page 1: ...XL RAID 213SA User Manual ...
