10) Access control setting
：
10.1) Press the **22# button
，
then the call station will switch to the status of access control setting. Meanwhile ,the call
station will display GuardCommand
。
10.2)
Press “#” button to enter into access control setting status (The initial password of access control is 1234).At this
time, the call station will cre
ate two “DiDi” tones. It means that the call station had entered the access control
setting status.
10.3) Add the cards by serial number of cards: Press 0 button
，
input the former 10-digits card numbers you want to add,
and then press the # button to confirm
10.4) Add the cards by contacting cards: Press 1 button
，
then contact the cards you want to register successively, then
press # to confirm
10.5) Delete the cards by serial number of cards
：
Press 2 button
，
input the former 10-digits card numbers you want to
delete, then press the # button to confirm
10.6) Delete the cards by contacting cards: Press 3 button, then contact the cards you want to delete successively, then
press # to confirm
10.7) Delete all the cards: Press 4 button , then press # to confirm
。
10.8) Door is in NO status: Press 5 button , then press # to confirm
。
It will return to normal status after contacting cards
。
10.9) Door is in NC status: Press 6 button, then press # to confirm. It will return to normal status after contacting cards
10.10) Only unlock the doors once: Press 7 button, then press # to confirm.
10.11) Change the password of access control: Press 8 button then input the new 4-digits password.Press # to confirm.
10.12) Exit the setting status
：
Press * button
Note: After entering the setting status, it will auto-exit if without any operations within 10 S .If you want to re-enter,
then you press
“password and # “button
10.13) Unlocking time setting
Timing pin
Unlocking time is 5S
Unlocking time is 1S
10.14) Management card setting
：
Status pin
Working status
Management cards
setting status
10.14.1) If the pin is in management card setting status .You need to re-power; the 1
st
card is to add the cards, the 2
nd
is to delete cards .Then you power off .And put the pins in working status.
10.14.2)
Add cards: the procedure is to contact the “Add cards”, then add the cards you want to register, and then
contact the “Add cards “again.
10.14.3)
Delete cards: the procedure is to contact the “delete cards”, then delete the cards you want to delete, then
contact the “delete cards “again.