DIP Switch Setting
The DIP switch is designed to set the code for door station and monitor, there are two states for
each DIP switch, please refer to the following sketch map.
ON(1)
=
OFF(0)
=
Door station DIP setting
Total 3 bits can be configured, bit-1 and bit-2 are used to assign ID code for door station, bit-3 is
used to match the video impedance.The switches can be modified either before or after installation.
Bit state
Description
ON
1 2
3
ID = 0(00), set to the first door station
ON
1 2
3
ID = 1(10), set to the second door station
ON
1 2
3
ID = 2(01), set to the third door station
ON
1 2
3
ID = 3(11), set to the fourth door station
Note: if the video impedance need to match, please set the bit-3 on.
Indoor monitor DIP setting
There are 6 bits in total. The DIP switches are used to configure the user code for Monitors.
Bit-6 is an video impedance match switch, which have to be set to ON if match the impedance,
otherwise set to OFF.
Bit-1~Bit-5 are used to set user code, to
DPC-D246A
door station, the user code should set to
0~15. Please refer to the following settings:
Summary of Contents for DPC-D246A
Page 1: ...2 Wire Video Intercom System DPC D246A User s manual...
Page 10: ......
