2
Inner Power 1 Lock Connection
•
Lock Control Jumper:
To select the lock type: when connecting a Electromechanical lock, set the jumper in 1-2
position; when connecting a Electromagnetical lock,set the jumper in 2-3 position.
•
Camera Code DIP:
Total 4 Camera can be supported
1 2
ON
Set to the first Camera when multi Cameras are to be installed;
Set to the Camera when there is only one Camera to be installed;
1 2
ON
Set to the second Camera when multi Cameras are to be installed;
1 2
ON
Set to the third Camera when multi Cameras are to be installed;
1 2
ON
Set to the fourth Camera when multi Cameras are to be installed;
•
Main Connect Port:
To connect the bus line and the electronic locks.
• BUS: Connect to the bus line, no polarity.
• PL: External lock power input, connect to the power positive(power +).
• S1+, S2+: Lock power(+) output, to connect 2 locks.
• S-: Lock power(-) output, connect to the power(-) input of locks(only when using the camera to power the locks,
if using the external power supply for the locks, the S- will not be connected).
The standard inner power lock connection, use the Camera power to supply the lock, no need for external power
supply. The Unlock Mode in the monitor need to be set: for Power-to-Unlock type lock, Unlock Mode set to 0(in
Monitor, goto Main--> Setup--> Advanced Set--> Information page, then press and hold the Unlock Button for 2
seconds to open the Unlock Mode setting page); for Power-Off-to-Unlock type lock, Unlock Mode set to 1.
1
2
O
N
1 2 3
to Monitor
-
+
BUS PL S1+ S2+ S-
BUS PL S1+ S2+ S-
Jumper position in 1-2
Unlock Mode
0: power-on-to-open
1: power-off-to-open
The lock consumption must not
greater than 12V 500mA.
Electromechanical lock
1
2
O
N
1 2 3
to Monitor
-
+
Jumper position in 2-3
The lock consumption must not
greater than 12V 300mA.
Electronmagnetical lock
CALL
UNLOCK
TALK/MON
IN-USE
MENU
Unlock Mode
0: power-on-to-open
1: power-off-to-open
CALL
UNLOCK
TALK/MON
IN-USE
MENU
Connection for Electromechanical lock
Connection for Electromagnectical lock
