DMX-TR1 Xplorer
©
2019 XTEC Industries
v1.1
Page 8 of 12
2 Getting Started
First, solder the headers onto the board, as shown in Figure 2-1.
Figure 2-1 Solder headers on DMX-TR1 Xplorer
Then connect the board into a mikroBUS slot on your development board, as shown
, and you’re off! The
DMX-TR1 Xplorer
will now receive and transmit DMX
data through the terminal block.
You can also mount the DMX-TR1 Xplorer onto a breadboard. Just make sure your
connections (such as SPI and power) are correct.
To communicate with the XT1401A processor on the DMX-TR1 Xplorer so you can
change data transmitted and read data received, check out the XT1401A-I/ST -
DMX512 Guide found at
Y
ou’ll also find there code examples for many popular development boards, such as
Arduino and Raspberry Pi.
