7
8
CHAPTER 3 PILOT RUN AND PROCESSING
3-1 PILOT RUN
1. Select auto mode. If the system has not performed mechanical homing, execute
“Home” function.
6. Click “HOME” button to execute axis mechanical homing operation. When homing is
completed successfully, “HOME” button is highlighted, indicating that the homing function
is normal.
7. Switch back to the manual operation interface. The highlighted “T1”, “T2” or “T3”
indicates the current bur number on the spindle. When first put the milling burs into the
spindle, please check if there is a protection bar inside the collet. Use left hand to hold
tight the protection bar and click “COLLET”. Then take out the protection bar and put T1
(the biggest bur) into it. Check if the NO. behind T on the screen is 1 or not. (like picture
below)
If the NO is 1, then click “T2” on the manual interface and machine will put T1 bur into the
tool station. After, you can put T2 bur into spindle. Then check tool NO. on the screen and
click “T3”. Machine will put T2 bur into tool station and you can put T3 bur into the collet
manually. At this time, you can click “T1”, “T2” and “T3” respectively to check if the tool
change is normal.
8. When the bur changing operation is completed, click “TLC” button to execute the auto
tool length checking operation. Watch this action and check if it is normal. Now, the instal-
lation and commissioning are finished.
Figure 2-2
