XTBA “Product Name” Page 3 of 8
Product #01512 July 2014 © XTBA 1986 – 2015
Pushing the ← button in receive mode sends the display counting to the left.
Pushing the ← key once will give one channel movement to the left. Holding it
down will cause the screen to scroll until the button is released. Unsurprisingly
the Right does the same but in the other direction.
The channel numbers will wrap around in either direction from 1 to 512 going
left and 512 to 1 going right. Pushing both ← and → keys simultaneously will
set the display back to channel one.
Transmit DMX
Pressing the → key when transmit DMX is displayed will prompt ‘ARE YOU
SURE’ on the display. Pressing FUNCTION will loop back to receive, pressing
the → key again will enter the transmit submenu.
When in transmit the splitters DMX input is disconnected and the splitters
outputs (including the loop through) are controlled from the local control unit.
Any RDM messages will be ignored. When in transmit the green data led will
flash.
Transmit Single:
C H A N N E L
0 0 1 T O
5 0 %
<
>
u p /
d o w n
f
u n = e s c
The ← and → keys will change the channel to be transmitted the up and down
keys the transmitted level. Pressing both the ← and → keys will go to 001 and
pressing the up/down keys will set the level to 50%
Transmit Multiple
C H :
1
2
3
4
T X :
%
5 0
3 7
2 3
F F
TX will be displayed in the lower left of the screen. All 512 channels can be
controlled using transmit. The first channel on the left of the screen can be
selected by using the ← and → keys and this channel will be controlled. The
up/down keys will alter the level. Pressing both the ← and → keys will go to
001 and pressing the up/down keys will set the level to 50%
Parameters Functions
In Parameters Mode the display is changed to display DMX timings and values.
The top line of the display shows what is being measured the figure below is
the value, as follows:
B R K
M A B
S C D
C H N
S Y S
9 2
1 0
0 0 0
5 1 2
O K
BRK
DMX Break Time in micro seconds (us)
MAB
Mark after break time in micro seconds (us)
SCD
Start code in decimal
