Page
12
DP224/6
Operators
Manual
Operating
the
DP226
Note about operation with
Windows
TM
software.
The following operating information covers control of the DP226 via the front panel
controls only. Please consult the manual supplied with this software for information
regarding computer control.
Preliminary Set-up
The procedure below should be followed when first installing a DP226.
Design your crossover! To do this, press MENU, and use the BACK or NEXT
key to select ‘X-over sub-menu’ and then press ENTER. Use the BACK or
NEXT key to select ‘Design a X-over’ and then press ENTER. Finally, use the
BACK or NEXT key to select the desired configuration and follow the set-up
wizard to finalise your design.
Note that when in a menu, ENTER is always used to confirm selections. The
current selection is marked with an asterisk ‘*’.
Use the GAIN keys on each output channel with the BACK and NEXT keys to
select the high pass filters, low pass filters, parametrics etc. Note that when
designing a new crossover, the high and low pass filters will be set to default
values. See appendix 2 for more information.
Use the GAIN keys on each input channel with the BACK and NEXT keys to
select the gain, delay and parametrics available on each input.
Note that if no action is taken in menu mode, the unit will return to
normal ‘default’ mode after about twenty (20) seconds.. Repeat the
above directions to return to menu mode.
Summary of Contents for DP226
Page 1: ......
Page 18: ...Page 18 DP224 6 Operators Manual Screen Layouts Overview...
