Xstream X-HWTR3524GEN, Operation Manual

Page: 22 / 40

22
operation
Operating Instructions
FlUSHING THE SySTEM
This unit has a steel coil which, after setting, will cause the water remain-
ing in the coil from the previous usage to turn brown or black. This water
must be flushed from the system before start-up. This procedure should
be performed WITHOUT the high pressure hose, gun and lance assem-
bly installed.
1. Turn on the water supply.
2. Start engine on unit. Low pressure water will begin flowing from the
water outlet. This allows the unit to flush any particles from the system.
The unit is flushed when the water is clear.
3. Once the system is flushed, turn off engine and connect the high pres-
sure hose to the water outlet of the unit.
4. Connect the trigger gun and dual lance assembly to the high pressure
hose.
5. Install desired nozzle into dual lance assembly.
CAUTION
BE CERTAIN THE HOSE, GUN & LANCE ASSY. ARE NOT
CONNECTED TO THE UNIT WHILE PRIMING THE PUMP. PRIMING
ALLOWS MINERAL DEPOSITS TO BE RELEASED FROM THE
SYSTEM WHICH WOULD OBSTRUCT OR DAMAGE THE GUN
AND NOzzLE ASSEMBLY RESULTING IN COSTLY REPAIRS.
START-UP/COlD WATER OPERATION
CAUTION
DO NOT ALLOW SPRAY PATTERN TO REMAIN ON A FIXED AREA
FOR AN EXTENDED PERIOD OF TIME. POSSIBLE DAMAGE MAY
OCCUR TO THE AREA.
WARNING
KEEP CLEAR OF NOzzLE! NEVER PLACE HAND OR FINGERS IN
FRONT OF NOzzLE!
DO NOT DIRECT DISCHARGE STREAM AT PEOPLE OR PETS!