section is restored to 15°).
Note: this angle is not saved after the machine is powered off, and is
only valid when the machine is continuously used after power on.
(3) When the machine (lithium battery switch) is powered on, the
automatic adjustment default angle is : 10 °
After the CT420SC (lithium battery switch) turns on, it switches to the
automatic adjustment mode for the first time with the horizontal
angle less than 7°. At this time, The CT420SC will adjust the horizontal
angle of loading board to 10°.
Switch to the automatic adjustment mode when it is more than 7°, and
the adjustment of the loading board shall be subject to the 3.5.1(1).
(4) If it is found that the hand-held Controller is in the state of speed
limit for a long time, or there is a continuous buzzer alarm sound from
the CT420SC, please stop using the machine, and refer to the
maintenance manual for fault detection.
3.6 Go Upstairs
3.6.1 Start the CT420SC stair climber
For the first use, you need to insert
the plug under the battery base. In
the daily use since then, there is no
need to insert or to remove the
plug.
