To convert from DIN to Yoke, remove four parts of the DIN connection which are the Filter Retainer
Screw, DIN Wheel DIN Connector Body and the conical filter inside the DIN Connector Body as
shown in fig.3. Always use a Vice with protected jaw with ether Rubber, Nylon, Plastic or Wood
blocks as shown below. Yoke conversion Parts are now included with OMS regulators and are shown
in Fig.13
Using a 6mm Allen tool, remove the Filter Retainer, if you find it hard to loosen the filter
Retainer Screw, use a short piece a pipe or the end of a wrench or adjustable tool as shown in fig.4 for
extra leverage.
DIN Parts to be removed from Regulator.
Fig.3 Fig.4
If you find that all three piaces come off at the same time, as shown in fig.5, , then go directly to
Fig.9…If not, continue thru fig.6…8.
Fig.5 Fig.6