CASTER
ROLL CENTER
980210
P 2x10
Bearing with STEEL
covers
26
2x
2x
L=R
L=R
SHORT AXLE
CVD DRIVE SHAFT (83mm)
NOTE
ORIENTATION
LOWER ROLL CENTER
TOP = LONGER bushing & 3x14 screw
BOTTOM = SHORTER bushing & 3x12 screw
TOP = SHORTER bushing & 3x12 screw
BOTTOM = LONGER bushing & 3x14 screw
HIGHER ROLL CENTER
CONICAL SHIM 3x6x2mm
Longer bushing
Longer bushing
Longer bushing
Shorter bushing
➊
➋
➌
➌
➍
➊
➊
➋
➌
➌
➊
➋
➌
When inserting the bushings, make sure
that bushings are inserted equally on both
right and left hub to give the same roll
center position.
Be sure to use the shorter screw with shorter bushing and longer screw with longer bushing.
INITIAL SETTING
INITIAL SETTING
IMPORTANT (LEFT = RIGHT)
IMPORTANT
NOTE
ORIENTATION
940513
BB 5x12x4
359050
BB 5x10x4
902205
SH M2x5
362280
CON. SHIM 3x6x2
902312
SH M3x12
902314
SH M3x14
980210
P 2x10
5x12x4mm
5x10x4mm
8mm THREAD
Longer screw
Shorter screw
=
=
DETAIL
DETAIL
4. FRONT TRANSMISSION
#106210 HUDY GRAPHITE GREASE
#106213 HUDY JOINT GREASE - OPTION
XRAY BALL-BEARINGS
#940510 5x10x4 OIL
OPTION
#940512 5x12x4 OIL
OPTION
#359050 5x10x4 GREASE INCLUDED
#940513 5x12x4 GREASE INCLUDED
Use HUDY Ball-Bearing Grease
#106220 - STANDARD
#106221 - BLUE
#106222 - RED
DIRT
CARPET
DIRT
CARPET
FRONT DRIVE SHAFTS (2.5mm PIN)
#365201 ECS
81mm
OPTION
#365202 ECS
83mm
OPTION
#365222 CVD
81mm
OPTION
#365225 CVD
83mm
INCLUDED
#365226 CVD
84mm
OPTION
OPTIONAL HEX HUB EFFECTS
Different off-set hex hubs are used to
increase or decrease the track-width.
LESS OFF-SET
Rear - more traction
Front - more steering
MORE OFF-SET
Rear - less traction
Front - less steering
WHEEL HUBS 12MM
#4.5mm 6 SLOTS OPTION
#3.75mm 5 SLOTS OPTION
#3.0mm 4 SLOTS OPTION
#2.25mm 3 SLOTS OPTION
#1.5mm 2 SLOTS INCLUDED
#0.75mm 1 SLOT OPTION
#365353
0mm 0 SLOTS INCLUDED
#365354 -0.75mm Lightw. OPTION
#365361 -1.25mm Lightw. OPTION
#360900
ALU STEER. BLOCKS & 7º C-HUBS - SET
