Xray T4 2018, Instruction Manual, Page: 34 / 36

34
GEARING ADJUSTMENT
902308
SH M3x8
903308
SFH M3x8
#303061
GRAPHITE MOTOR GUARD
Adjust the motor so the pinion meshes
with the spur gear properly. Make sure
the gear mesh is not too tight.
There should be a small amount of play
between the teeth of the pinion gear and
the spur gear.
DETAIL
#306410-O
ALU FAN MOUNT
7. FINAL ASSEMBLY
Double-sided Tape
HUDY #107875
(NOT INCLUDED)
Receiver
(NOT INCLUDED)
Speed Controller
(NOT INCLUDED)
Feed the receiver wire
into the antenna tube
NOTE: In case the antenna tube does not hold the antenna properly, apply a small
drop of the CA glue to the outside end of the antenna tube while inserting it into
the holder. Make sure not to apply glue to the inside of the antenna tube, or the
antenna wire may get permanently stuck.
Motor & Pinion
(NOT INCLUDED)
3x2.5mm set screw
(#901302)
(NOT INCLUDED)
Some motors do not have a chamfer on the motor housing.
If your motor does not have a chamfer on the housing and
you want to use a small pinion, the motor may touch
the top deck. Use a moto-tool with grinding bit or file to
remove material from the top-deck; this will allow the
motor to be moved closer to the spur gear.
CA