42
903310
SFH M3x10
908310
SCH M3x10
902306
SH M3x6
8. ENGINE & CLUTCH
The engine should be installed on the split mounts as follows:
STEP 1:
Attach lower mounts to chassis.
STEP 2:
Attach upper mounts to lower mounts.
STEP 3:
Attach engine to upper mounts.
STEP 4:
Loosen lower mount screws, adjust gear mesh, and then retighten
lower mount screws.
After the gear mesh is initially set, you can remove the engine AND upper
mounts as one assembly by removing the screws holding the upper mounts
to the lower mounts. When re-installing the engine, you will not have to
re-adjust the gear mesh.
➊
#338721
BRASS 1-PIECE ENGINE MOUNT
Reinforces the chassis flex around the engine area and moves the weight
balance more to the rear for even more steering and rotation of the car.
RECOMMENDED FOR HIGH-TRACTION TRACKS
#338713
ALU MONOBLOCK ENGINE MOUNT
Reinforces the chassis flex around the engine area for improved steering.
RECOMMENDED FOR MEDIUM-HIGH TRACTION TRACKS
Adjust gear mesh so there is minimal
play between the gears.
Too TIGHT gear mesh will put excessive
strain on all parts and damage the parts.
Too LOOSE gear mesh may result in
stripped gears.
DETAIL
➋
Attach manifold to engine
using appropriate springs
Thread lock
(screw NOT INCLUDED)
NOTE
ORIENTATION
NOTE
ORIENTATION
Summary of Contents for NT 1.2
Page 1: ......
