Page 8
Two types of confirmations are displayed on the remote:
Command confirmation
: These confirmations are command acknoledgement, the icon
corresponding to the command is displayed to confirm reception of the command.
Status confirmations
: These confirmations are displayed when the status of a zone,
monitored by the system, changes (i.e.: door openning, security system alarm state (only
if the Factory Alarm Trigger Monitoring feature is supported by the firmware), etc. - it
depends on which firmware you are using).
Command confirmations are returned immediatly following a command transmission
whereas the status confirmations may be returned up to 12 seconds after the event
happened depending on the communication protocol between the hand-held unit and the
vehicle.
Remarks
: When the remote receives a confirmation that is intended to a vehicle other that
the one actually selected, most audible confirmations are made more discreet, vehicle
icon flashes (1-4) to warn you that the display reflect the status of that specific vehicle.
This is only applicable if the Factory Alarm Trigger Monitoring feature is supported by the
firmware.
When a command is transmitted, the vehicle selection gets back to the previously
selected unless the confirmation was related to an alarm condition.
In that case the selected vehicle is temporarely changed, to allow stopping the alarm
condition without having to change the vehicle selection, then gets back to previously
selected when the alarm condition is stopped.
The following diagram shows the usefulness of each icon of the display. Descriptions in
CAPITAL letters show confirmations pertaining to the security system’s functions.
1
2
3
4
5
15
14
6
16
1
Transmission
Battery charge indicator
2
Vehicle out of range
Auxiliairy outputs status
Sentinel mode status
SECURITY SYSTEM STATUS
IGNITION STATUS SENSOR
Remote starter status
HOOD STATUS
Valet mode status
Vehicle identification
3
Reception
4
Unlocking
5
Locking
6
7
8
TRUNK LID STATUS
9
14
15
16
10
11
12
13
DOORS STATUS
9
13
12
11
7
10
8
* Only if the Factory Alarm Trigger Monitoring feature is supported by the firmware.
2-Way LED & LCD Remote Start Kits
Rev.: 20091218
© 2009 Directed Electronics. All rights
Model: CHRSALL RS-CHLED & RS-CHLCD
