Rev.: 20191108
Platform: DBALL2
Firmware: BMW03
© 2019 Directed. All rights reserved.
1
Solid
Wait until the LED turns ON solid red.
&
3
Important:
Do NOT press the brake pedal.
Press the Push-to-Start (PTS) button twice to turn the ignition ON.
Do NOT
press the
brake pedal
4
2
Make sure the key is inside the vehicle.
Key Inside
the Vehicle
For Type 1 vehicles
Go to the next page to make the module programming for type 2 and 3 vehicles.
START
STOP
2X
PUSH
Module Programming
Important
Make all the required connections to the vehicle, as described in the wiring diagram(s) found in this guide, and double check to
ensure everything is correct prior to moving onto the next step.
Warning!
To take advantage of advanced features, you must use XpressVIP 4.5 or higher. Using version 2.9 or 3.1 will limit
available functions and features.
1. Connect the interface module to your computer using the
XKLoader2
.
2. Open an Internet Explorer browser (version 6 or higher), and go to www.xpresskit.com. The detail of the platform and firmware
that is currently saved on the interface module will be indicated in the top left corner of the page.
3. Select the
year
,
make
and
model
of the vehicle; the page will refresh to display the compatible firmware.
4. In the search result page, select one of the available install options (config for RSR, RXT or Standard install), and follow the
instructions provided on the screen.
5. Once you have configured your options, click on the
FLASH
button to upload the firmware onto the interface module.
6. The following message will be displayed when the upload is completed:
“The flashing is successfully completed. You may now unplug the kit.”
You can now proceed with the programming instructions below.
OR
If required for your installation, connect the 10-pin, 12-pin and 14-pin
harnesses to the module, then connect the 4-pin D2D harness.
D2D Installation
If required for your installation, connect the 10-pin and 12-pin harnesses
to the module, then connect the 14-pin harness to the module.
W2W Installation
10-pin
D2D
st
1
12-pin
14-pin
nd
2
rd
3
10-pin
D2D
st
1
th
4
12-pin
14-pin
nd
2
rd
3
Refer to the LED Diagnostics section on page 15 for more information and for troubleshooting purposes.
You have successfully completed the module programming sequence.
Page 11
START
STOP
E
E
N
N
GI
1X
PUSH
&
&
Solid x3 secs
OFF
The LED turns ON solid green for 3 seconds, then turns OFF
once the module has been successfully programmed.
Press Once Push-to-Start (PTS) to turn the Ignition OFF
