6
ADDING ADMIN FINGER
1.Push dip switch no.2 in position ON.
2.Reset the Power of the device.
3.Wait for One long + multiple short beeps
4.Put the dip switch in position OFF. (short beeps will stop)
5.Wait for about
15 seconds
for the LED to blink in Orange.
6.Swipe the Master finger min.6 times. (Until Ok Beep)
No.2
No.2
Warning:
This procedure also deletes all the users and the installer finger.
Warning:
This procedure will unpair the connected relay unit (RTT, DINRTT or RU2)
x
6
ON
1 2
ON
1 2
Tricolor Status LED
- Access Granted
Green
- Access denied
Red
- Idle Mode
Orange
OK Beep
- short + long beep
- 3 short beeps
Error Beep
Swipe Finger - 2 short beeps
INDICATION
Follow the below instructions for correct finger swiping. Starting from the first finger joint, place the
selected finger on the swipe sensor and move it evenly towards oneself in one steady movement.
Result:
For a valid swipe: Tricolour Status LED turns green + OK Beep(short + long beep)
For an invalid or misread swipe: Tricolour Status LED turns red + Error Beep ( 3 short beeps)
RECOMMENDED SWIPING TECHNIQUE
12/24V AC/DC
