XPower B-3J, Owner'S Manual

Page: 2 / 6

Table of Contents
Introduction ................................................................................................................................
Operation ...................................................................................................................................
Specifications .............................................................................................................................
Safety Instructions .....................................................................................................................
Parts List ....................................................................................................................................
Warranty / Service .................................................................................................................
Warranty Registration Form ......................................................................................................
1
2
3
4
5
7
8
9
1. Place the dryer on a flat surface. Plug the electrical cord into a 3-prong GFCI outlet.
2. To use as a dryer, connect the hose to the front hose connector and attach the desired nozzle.
Keep the inlet filter and crossed cover in place on the rear cover. Turn on the switch to the
desired speed.
3. To use as a vacuum, detach the hose from the front connector, then remove the inlet filter and
crossed cover of the rear cover. Connect the hose to the rear cover connector and attach the
desired nozzle. Turn on switch to the desired speed to vacuum.
4. All units in use must be supervised at all times.
Operation
:
To use as a dryer:
connect the hose to the
front hose connector.
To use as a vacuum:
connect the hose to
the rear cover
connector.
6,
- 2 -
Important: Open the air bleed hole on the tip of the hose when vacuuming to avoid overheating
and damage to the motor