Side view (Fig. 3)
No. Name
1
Shock absorbing rubber sleeve
2
Front transition piece
3
Nylon hook
4
Lower valve cap
5
Handle
6
Rear transition piece
7
Metal handle
8
Drain valve
Connection/Installation
1.
Inserting the battery:
Remove the screws from the battery compartment cover and open it.
Insert the two batteries (pay attention to the direction!) and then close the battery compart-
ment cover again.
2. Attach the air hose to the front transition piece of the unit and tighten it. Then attach the
quick coupling to the rear transition piece. Tighten it so that no air escapes.
3. Connect the quick coupling to the air supply line. The unit is then ready for operation.
Notes:
Disconnect the air supply hose from the unit when it is not in use. This will prevent damage.
Install an air dryer or an oil and water separator in the air supply.
Application
This product is designed to inflate, deflate and measure air pressure. This is done by lifting the valve
piston on the upper and lower valve attachments.
1.
Measure pressure:
Attach the air hose connector to the tyre (make sure there is no air
leakage). Read the pressure when the handle is at rest.
2.
Inflate:
Push the handle down; then you can inflate with the device.
3.
Deflate:
If the tyre pressure is too high, you need to deflate. To do this, simply press the air
release button.
4.
Using the buttons:
UNIT to convert units (long press to switch off), LIGHT to switch on the
backlight.
https://www.XPOtool.com
Item 63039
Page 5
The Tool Experts
05 2021
-1