https://www.XPOtool.com
Item 63021
Page 3
The Tool Experts
05 2022-1
Introduction
Thank you for choosing to purchase this quality product. To minimise the risk of injury, we ask you to
always take some basic safety precautions when using this product. Please read this operating manual
carefully and make sure that you understand it.
Keep these operation instructions in a safe place.
Safety instructions
Attention:
When you smell gas:
•
close gas supply.
•
extinguish open flames.
•
With gas smell persisting, immediately call gas supplier and fire brigade.
•
Never store or use petrol or other highly flammable vapours and liquids near this device or
similar devices.
•
A disconnected liquid gas cylinder must not be stored near this device or comparable devices.
•
Only suitable for outdoor use or in very well-ventilated areas. In such an area, at least a quarter
of its total surface must be open. The total surface of an area is the total of its wall surfaces.
•
Improper installation, adjustment, structural changes, maintenance, or care can cause property
damage or injuries. Read the assembly, operation, and maintenance instructions carefully and
completely before you start using the device.
•
The device and gas cylinder must be set up in accordance with the applicable regulations.
•
The ventilation slots in the gas cylinder housing must not be blocked.
•
The device must not be moved while in operation.
•
Gas lines and hoses must be replaced within the prescribed periods.
•
Only gas and gas cylinders corresponding to the manufacturer’s instructions may be used.
•
A space with a maximum diameter of 29
cm and a height of 70
cm is available in the heater for
the gas cylinder (not included in the scope of delivery). In strong winds, special care must be
taken to ensure that the heater cannot fall over. The distance between the device and the gas
cylinder must be at least 1
m.
•
The injector of this device cannot be removed, it is only connected at the factory. It is forbidden
to modify the device in such a way that it works at a pressure other than the set pressure.
•
Do not connect the gas cylinder directly to the device without interposing a pressure reducing
valve. Only use the gas and the type of gas cylinder specified in the instructions.
•
The pressure reducing valve must match the respective device type in accordance with DIN
EN16129:2013 and national standards:
◦
A 30
mbar pressure reducing valve is used for butane/propane of category I3BP(30).
◦
A 30
mbar pressure reducing valve is used for butane of category I3+(28–30/37).
◦
A 37
mbar pressure reducing valve is used for propane of category I3+(28–30/37).
