https://www.XPOtool.com
Item 62975
Page 4
The Tool Experts
01 2022
-1
•
Use the correct size and type of extension cord. If required, an extension cord must be of the
correct size and type to provide the correct power to the device without its heating up. Other-
wise, the extension cord could melt and catch fire or damage the device. When using the device
outdoors, use an extension cord suitable for outdoor use.
•
Maintenance: For your safety, maintenance should be carried out regularly by a qualified tech-
nician.
•
Never use the device near flammable materials.
Note:
The performance of this tool may vary depending on fluctuations in local voltage. The use
of extension cords can also affect the performance of the tool.
Warning:
The warnings, cautions, and instructions contained in this manual cannot cover all
possible conditions and circumstances. The operator needs to know that it is essential to be
careful when operating the device.
Additional safety instructions
Warnings concerning grinding discs
1.
Do not use a grinding disc that pieces are broken from, that is cracked or worn. Check whether
the disc has cracks not visible by hanging it by the centre hole and slightly tapping it with a non-
metallic object (e.g., screwdriver handle). When in good condition, it will produce a metallic
sound. A clunk indicates a crack or break.
2.
Only use standard discs with a diameter of 100
mm. Other discs may burst under the load and
endanger the operator and bystanders.
3.
The disc diameter must not deviate more than 15
mm from the normal radius. Discs with a di-
ameter of less than 70
mm must not be used under any circumstances.
4.
The disc must rotate clockwise as indicated by the arrow on the cover.
5.
Only use discs that can withstand a minimum speed of 7500
rpm or more.
6.
Never use the chainsaw sharpener without the cover of the grinding disc in the intended place.
7.
Always test the grinding disc by running it for one minute before putting it on the chain.
8.
Stay away from the grinding disc when it is rotating and make sure that no one is standing near
or in the line of the disc rotation.
9.
With the grinding disc vibrating, switch off the machine immediately and check that it is securely
mounted and not damaged.
10.
Never try to stop the grinding disc with your hands, even if you are wearing protective gloves!
The disc cuts through your gloves and can seriously injure your hand!
11.
The specified speed of the replacement grinding disc must at least reach or exceed the speed
of the tool.
Warning!
This machine is designed to sharpen chainsaw chains. Do not try to sharpen other
tools or other objects.
Commissioning
Assembly
•
If you buy the grinding disc individually, refer to the instruction manual for replacement and
maintenance of the disc.
•
Use an M8 bolt that is long enough to attach the device to a workbench (see ill.). The device
must be attached as shown in Fig.
1 and Fig.
6.
Preliminary check
The machine must be at a standstill so that you can carry out the following checks:
1.
condition of the grinding disc and its profile;
2.
condition of the power cord;
