https://www.XPOtool.com
Item 62935
Page 4
The Tool Experts
01 2022
-1
Range of application
This submersible pump is usually installed in basements. There, it grants protection from flooding. Ad-
ditionally, the pump can be used, where water needs to be transported from one spot to another, e.g.,
at home, in agriculture, in gardening, for sanitary work and so forth.
Resistance
•
The maximum temperature of the pumped liquid should not 35
℃
in continuous oper-
ation.
•
The pump must not be used to pump flammable, gassing, or explosive liquids.
•
The pump must not be used to pump other liquids, especially motor fuels, cleaning agent, or
other chemical products.
Installation
The pump is installed the following way: in a fixed position either with fixed or flexible tubing.
Attention!
•
When installing the pump, make sure not to freely suspend it with its pressure line or power
cable. The submersible motor pump needs to be hung up by the appropriate handle or placed
on the floor of the shaft.
•
To ensure the impeccable functioning of the pump, the shaft floor needs to be kept free of mud
and dirt of any kind.
•
If the water level is too low, the mud on the shaft floor might quickly dry and hinder the pump
from starting. It is therefore necessary to regularly check the pump (by performing tests before
operation).
•
The float switch is adjusted to allow the pump to start immediately.
Note:
The pump shaft should have a minimum size of 40×40×50
cm, so that the floater can move freely.
Mains connection
The pond pump that you have purchased is already equipped with a protection plug. The pump is meant
to be connected to a 220/230
V~50
Hz safety socket. Make sure that the socket is sufficiently protected
(min. 6
A) and fully functional. Plug in the plug, the pump is operational.
Note:
If the cable or the plug is damaged due to external influences, the cable must not be repaired. It
must be replaced with a new one. This work can only be carried out by an electrician.
Operation settings
After carefully reading all information and instructions contained within this operation manual, the pump
can be operated by abiding the following steps:
•
Check if the pump is resting on the bottom of the shaft.
•
Check if the pressure line is properly attached.
•
Check if the electric source has 230
V~50
Hz.
•
Check if the socket is in a good condition.
•
Make sure that the electrical connections and circuits are sufficiently protected from moisture
and water.
•
Do not allow the pump to run dry.
