XPOtool 62883, Operation Manual, Page: 7 / 10

© by WilTec Wildanger Technik GmbH Article 62883, 62884 Page 7
http://www.WilTec.de
http://www.aoyue.eu 01 2022 -1
http://www.teichtip.de
Replacing the carbon brush
This appliance has a device to replace worn car-
bon brushes. If there are large sparks during the
rotation of the device or the device stops running,
please replace the carbon brushes. Remove the
cover of the carbon brushes
(1) with a screw-
driver. Remove the worn brushes and replace
them with new ones. Make sure that the brushes
can be easily inserted into the holder by hand and
then tighten the cover again. Make sure that both
brushes are replaced at the same time.
Technical data
Rated voltage (V) 230
Rated frequency (
㎐
) 50
Power input (W) 1200
Max. (no-load) speed ( r ⁄
min
) 3000
Grinding wheel diameter (
㎜
) 180
Support plate diameter (
㎜
) 150, 180
Polishing fleece diameter (
㎜
) 180
Polishing sponge diameter (
㎜
) 150