https://www.XPOtool.com
Item 62830
Page 4
The Tool Experts
05 2022
-1
exchange of sanding disks. Abide by the instructions concerning the replacement or lubrication
of parts.
•
Before connecting the device to a power supply, ensure that its on/off switch can be moved
without any obstructions. Do not use the device if it cannot be turned on or off properly. Always
make sure that the device has been turned off before connecting it to a power supply and only
connect it to an outlet matching its specifications.
•
Only attach and use the equipment in accordance with this operation manual. Always make
sure to use accessories corresponding to the task at hand, since the use of unsuitable acces-
sories can affect the efficiency of the device and even cause accidents.
•
Turn the device off, disconnect it from its power source, and wait for its moving parts to stop
before storing it.
•
In case of spare parts being needed, make sure to only use matching parts of equal or better
quality.
Voltage
Before connecting this tool to a power outlet or extension cable, make sure that its supply voltage
matches the rated voltage of the tool. In case of the supply voltage of the outlet being greater than the
rated voltage of the device, turning on the device may cause damages and injuries.
Do not attempt to keep using a power outlet with insufficient voltage supply, as a voltage supply lower
than the rated voltage of the device may damage the same.
Application
•
This device is a hand-operated electric tool and mainly intended for working on chalk surfaces,
such as inner walls, ceilings, and outside walls.
•
Remove the lime slurry from the wall and smooth its surface to potentially increase the efficiency
and quality of your work.
•
This tool can easily adapt to the conditions of its work environment as it can efficiently operate
at high as well as low speeds, allowing for the optimization of the sanding process while granting
a user-friendly handling. This device is equipped with a suction function capable of reducing the
dust loading during the process of sanding.
Technical Specifications
Rated voltage
(V)
230
Frequency
(
㎐
)
50/60
Rated power
(W)
1240
Idle speed
(
r
⁄
min
)
1400–2600
Disk wheel diameter
(
㎜
)
215
Sanding disk diameter
(
㎜
)
225
