https://www.XPOtool.com
Item 62547
Page 8
The Tool Experts
05 2022-1
After commissioning
In case you do not need the pump any longer, pull out the plug. Then let the device cool down to ambient
temperature and disassemble it. Maintain the parts. Finally, you may store the fountain pump in a place
designated therefore.
Replacing the power cord
Warning!
The power cord of this device cannot be replaced. With the power cord being damaged, the
entire device must be scrapped.
Cleaning and maintaining the pump
Warning!
Before maintaining the device, always pull the power plug.
Cleaning
•
Cleaning the device is recommended after every use.
•
Regularly clean the device using a damp cloth and a small quantity of soft soap. Do not use
detergents or solvents, for these substances might attack the plastic parts. Make sure that the
power cord and other electrical components are not damaged.
•
Water penetrating an electric device increases the risk of electric shock.
Maintenance
•
For the device to work during a long service life and for its operation to be uninterrupted, it is
advisable to regularly control and maintain the pump.
•
In case the head or flow rate drops, the filter must be cleaned with lukewarm water.
•
In case of hard water, regularly clean the rotating parts of the pump.
•
Before prolonged periods of non-use and before winter storage, the pump must thoroughly be
rinsed with water and completely emptied. Allow the pump to be stored in a dry place.
•
In case of risk of frost, the pump must entirely be emptied.
•
After prolonged periods of non-use, check by briefly switching on and off the device if the motor
turns freely.
To disassemble the pump, proceed as follows:
Always pull the plug beforehand!
1.
Loosen the suction basket
(2)
by turning it the direction of the arrow (see Fig.
4).
2.
Unscrew the screw counter-clockwise (Fig.
5, 1).
3.
Caution!
There are two washers at either end of the rotor that might fall out when you remove
the cover and rotor. Be careful not to lose them and put them back when re-assembling the
device.
4.
Turn the rotor cover on the underside of the pump counter-clockwise (Fig.
5, 2), then remove
the rotor (Fig.
6).
5.
Clean the rotor and pump with clear water, re-assemble the device in reverse order.
Storing
Store the device and its accessories in a dark, dry, and frost-free place. The best storing temperature is
between 5
℃
and 30
℃
. Store the device in its original packaging.
