https://www.XPOtool.com
Item 62541
Page 7
The Tool Experts
05 2022-1
•
Always pull out the power plug before working on the power tool (e.g., transport, assembly,
modification, cleaning, and maintenance).
•
The transparent protective shield
(4)
and spark protection
(5)
must be attached before use.
Attaching the spark guard
1.
Bring the slot in the spark protection
(5)
over the hole on the top of the wheel protection
(6).
2.
Place the circlip
(5b)
and a washer
(5c)
on the screw
(5a).
3.
Screw a screw
(5a)
through the spark protection slot
(5)
and the hole on the top of the wheel
protection
(6)
(see Fig.
1).
4.
Secure the screw
(5a)
with a tooth lock washer
(5e)
and nuts
(5d).
5.
Repeat steps 1 to 4 for the second spark protection.
Figure
1
Attaching the workpiece holder
The workpiece holder
(2)
must be attached to both sides of the bench grinder before use. Use the as-
sembly set
(10)
for fastening.
1.
Hold the workpiece holder
(2)
against the wheel protection rail. Make sure that the workpiece
holder is pointing in the right direction. The angled corner must point away from the bench
grinder (see Fig.
2).
2.
Screw one of the screws
(10a)
through the rail slot and the workpiece holder.
3.
Place a washer
(10c)
on the other end of the screw.
4.
Secure the screw
(10a)
with a lock nut
(10b).
5.
Repeat steps 1 to 4 on the other side for the second workpiece holder.
Figure
2