https://www.XPOtool.com
Item 62353
Page 6
The Tool Experts
05 2022-1
Warnings
Caution:
Please read and follow these instructions before operating the machine. There can be
unpredictable results if you do not follow them! For the safety of people and machines, please
observe them under all circumstances!
•
Check that the running machine is safe.
•
Only operate the machine in a suitable work area.
•
Keep other people away from the work area.
•
Make sure that the running machine is not exposed to water vapour.
•
Ensure that the work area is adequately lit.
•
Check whether the available mains voltage corresponds to the voltage specified on the type
plate of the device.
•
Check whether the machine is earthed or not.
•
The machine must not be overloaded.
•
Do not pull on the cord to remove the plug from the socket. Keep the cord away from heat,
moisture, and scratches.
•
Do not use cables that are worn or damaged in any other way.
•
Unplug the machine when not in use, when servicing, or when making adjustments.
•
Do not mix materials with a flash point below 21
℃
.
•
Do not use solvents to clean the tools.
•
Do not operate the machine if the immediate vicinity is at risk of fire or explosion.
•
Do not start the mixer until the stirrer is in the mixing drum or in another drum.
•
Do not let the machine idle.
•
Do not remove the stirrer until the machine has stopped. Do not touch the walls of the mixing
drum with the stirrer when the machine is running.
•
Do not start the machine if there is dried material in or hanging on the drum.
•
Careful operation of the machine increases its service life.
•
Please wear protective goggles and hearing protection when operating the machine.
•
Use only original spare parts for machine maintenance.
Operation
Assembly
1.
Take the two stirring rods out of the box (see Fig.
1).
2.
Insert the stirrers into the locking sleeves and slide them in until they click into place. The stirrer
shaft is automatically locked and held in place. Pull on the stirrers to check that they are properly
locked (see Fig.
2).
3.
Push back the locking sleeve of the stirring rod holder to remove the stirring rods again (see
Fig.
3).
Figure 1
Figure 2
Figure 3
