https://www.XPOtool.com
Item 61952
Page 3
The Tool Experts
09 2022-1
Introduction
Thank you for purchasing this quality product.
To minimise the risk of injury we urge that our clients
take some basic safety precautions when using this device. Please read the operation instruc-
tions carefully and make sure you have understood its content.
Keep these operation instructions safe.
Safety precautions
The owner and/or user must have read and understood the operating instructions before using the de-
vice. Instructed personnel should be careful, competent, trained, and qualified in the safe handling of
the equipment used. Warnings should be read and understood.
•
Do under no circumstances and at no point touch the machine with your fingers, as this can
lead to serious injuries.
•
We recommend the use of safety gloves to minimise the risk of injury.
•
Observe the applicable occupational safety and accident prevention regulations.
•
This equipment is not intended for use by people (including children) with reduced physical,
sensory, or mental abilities or people without appropriate experience or knowledge, unless they
are supervised by a person responsible for their safety or have received prior instruction in the
use of the equipment.
•
Children must be supervised to ensure that they do not play with the equipment.
•
Use a hair net for long hair.
•
In addition, the local accident prevention regulations, and general safety regulations applicable
to the area of application of the device must be observed.
•
If you have long hair, use a hair elastic and tie your hair up.
•
In addition, the local accident prevention regulations applicable to the area in which the device
is used and the general safety regulations must be observed.
Operation
•
First, make sure to adjust the distance between the blade and the shaft according to the size of
the cable that is to be stripped. Please make sure that the device is set to only strip the insulating
layer without damaging the inner conductors.
•
Thread the cable into the feed and adjust the same until the cable can be pulled through without
shifting the inside fixture.
•
Use the hand crank to strip the cable of its insulation layer by pulling it past the blade. Alterna-
tively, the hand crank can be removed from the device and can be replaced with a drill by utilis-
ing the drill connector bit.
•
Should the device be unable to separate the cable from its insulation, it might be due to one of
the following reasons:
◦
The diameter of the cable is too small.
◦
The blade is not positioned in the centre and has therefore to be adjusted.
◦
The blade has gotten dull and needs to be sharpened/replaced.
