https://www.XPOtool.com
Item 51707
Page 7
The Tool Experts
08 2022-1
Step
3: Mounting the long side of the axle shaft
ount these parts in the following
order on the long side of the axle
shaft. Observe the direction of the
insertion knives.
IMPORTANT:
ake sure that
the upper bracket of the centre sup-
port faces the short end of the axle
(A = long end)!
1. Start with a 0.79″ spacer
2.
⌀
20 washer
3. Central support
4.
⌀
20 washer
5. 1.61″ spacer
6. Double coil (knives point in-
wards)
7. Single coil
8. 2.76″ spacer
9.
⌀
20 washer
Step
4: Fastening the end plates and the wheel holder
Start by turning the wheel holder in the mid-
dle of the axle shaft so that it points up-
wards
(A).
Next, attach a side plate to one
side, followed by a
⌀
20 washer
(5)
and a
wheel holder. Note that the wheel carrier
ring is facing inwards. Fasten the wheel
bracket to the axle shaft with ¼″×1
9
⁄
16
″ hex-
agonal bolt and ¼″ locking nut.
Tighten the
connection firmly.
Repeat for the other
side.
1. Side plate
2. Wheel holder
3. Screws ¼″×1
9
⁄
16
″
4. Locking nut ¼″
5. Flat washer ⅞″
( )
( )/( )
( )
( )
(A)
( )
( )
(A)
( )
( )
( )
