
https://www.XPOtool.com
Item 51545–51547
Page 3
The Tool Experts
10 2022-1
Introduction
Thank you for choosing to purchase this quality product. To minimise the risk of injury, we ask you to
always take some basic safety precautions when using this product. Please read this operating manual
carefully and make sure that you understand it.
Keep these operation instructions in a safe place.
Safety instructions
The symbols
and the sentences including the words
“danger”
or
“warning”
wish to call
your attention to the dangers and possible consequences of non-compliance with the safety instructions.
Symbol
Danger: Non-compliance with the safety instructions might …
… lead to an electric shock.
… cause severe damages caused to your health.
… damage the pump.
General remarks
•
Make sure that the product has been installed correctly to work at its best.
•
All materials have undergone a meticulous inspection. Installing correctly the pump contributes
to the protection of the pump against damages and overcharge. Any non-compliance with the
instructions can cause damages to the pump.
•
Always use a non-return valve.
•
The pump must not be immerged into water. The water is sucked in via a hose.
•
Prime the pump and suction line with water before using it; otherwise, it will run the risk of
running dry.
•
Check if there is a water column (prime the pump with water before use until the water column
is present to 100
%).
Assembly
•
The pump must be set up on a level and firm surface.
•
The end of the suction line should be immerged at least 30
cm at the lowest point of the water.
•
The suction line must have a slope in water-sampling direction; that must be done so that the
line has no bends that could provoke a water accumulation.
•
Never hang up the pump by an electric cable or line.
•
Before use, make sure that there is a continuous water column.
•
It is advisable that you install a tube with a larger diameter than that of the outlet to reduce the
friction loss as much as possible.
•
Install a non-return valve to the entry of the pump to prevent that the line is emptied at every
stop of the pump.
•
Avoid that tube lines are bent or twisted and make sure that the connection to the outlet is
correct. In both cases, the flow at the outlet is reduced if the connection be bad.
Checks before start
•
Make sure that the existing mains voltage and frequency match the specifications on the name-
plate of the device.