Assembly descriptions
EN-3
EN
A
SSEMBLY
DESCRIPTIONS
Assembling the Xplova NOZA
1. Flip the box and open the bottom of the box.
Take the Xplova NOZA main unit and
Styrofoam packaging out of the box at the
same time.
2. Remove the front and rear bottom tubes from
the sides of the Styrofoam packaging.
(DO NOT open the Styrofoam packaging at
both sides.)
3. Take out the bolts and insert them into the bolt
holes on the main frame.
4. Put the front and rear bottom tubes on the main
frame, then push the bolts into bolt holes.
5. Use the wrench to tighten the nuts.
6. Flip the entire Styrofoam packaging
to make the Xplova NOZA bike
trainer stand upright on the floor
where it will be used. Remove the
Styrofoam packaging on both sides
to complete assembly of the bike
trainer.
7. Install the cassette (sold separately)
into the cassette body and lock the
cassette nut to prevent loosening.
Attention:
The Xplova NOZA bike trainer cassette body is compatible with Shimano
and SRAM cassette which can be directly installed with an 11-speed
cassette. If you are using a non-11-speed cassette, please fit the
cassette washer on the bottom of the cassette body first before installing
the cassette.
