7 8
The specific program waveform graph for each Natural Blower Mode is shown
below for each of the 3 speed selection modes (HI, MED, LOW
)
HI
MED
LOW
D. ECO Blower Mode:
When this mode is selected your product will automatically switch to operate in
different fan speed modes depending on the ambient temperature around the
product as follows;
- when the ambient temperature is less than 25
℃
it will operate at Low speed;
- when the ambient temperature is between 25
℃
and 29
℃
it will operate at Med
speed.
- when the ambient temperature is more than 29
℃
it will operate at Hi speed:
5) REMOTE CONTROL OPERATION
To activate the remote control release and slide out the battery holder from the
bottom back of the remote control handset (as indicated below), install your 3V
CR2032 button battery cell into its location ensuring the positive and negative pole
are as indicated on the label on the back of the remote and reinstall the battery
holder completely. Align to infrared receiver module when using remote controller.
Note - Remote Control will only operate the product if it is in direct line of site and
within a distance of 6 meters from the product. If it fails to do so under these
conditions after the product has been in use for some time please check the battery
is not depleted before taking any other action.
6) AUTO DIMMING FUNCTION
The LED lights on the control display will dim by 30% automatically after a 1 minute
delay if the controls are not operated/used to save energy.
7) LED DISPLAY DETAILS:
1
、
Double 8 digital display 15*14 mm, 0.36inch Common Cathode.
2
、
Apart from the digital display there are ten LED light function symbols as
indicated below,
LOW
MED
ON/
OFF
Sleeping
Natural
Swing
HI
Digital display
Timer
ECO
RC Receiver
Temperature
