☆
TECHNICAL SPECIFICATION
Specification Details - XPP
Symbol
Value
Unit
Maximum Fan Flow Rate
F
9.2
m³/min
Fan Power Input
P
32.3
W
Service Value
SV
0.3
(m³/min)/W
Standby Power Consumption
PSB
0.64
W
Fan Sound Power Level
LWA
64
dB(A)
Maximum Air Velocity
c
4.1
meters/sec
Rated Voltage
V
220-240
V
Rated Frequency
Hz
50
Hz
Measurement Standard for Service
Value
IEC 60879:1986
☆
HOW TO ASSEMBLE THE BASE
Carefully remove the split base and the tower fan from its packaging.
Pass the power cord between the two halves of the split base at the
centre and fit the two
halves’ together by lining up the overlap bosses
on the back half (with the cable exit) with their sockets on the other
half and dropping into place and pressing together.
Bring the assembled base up to the bottom of the tower and line up
the small pillar on the top of the raised centre of the base with the
matching hole in the base socket location of the tower fan, pull the
cable through fully
so it doesn’t interfere with them fitting together.
Take the 4 large screws provided and pass them through the holes
in the circular bosses (located around the central hub on the underside
of the base) into the bottom of the tower, screw fix them firmly in place.
Carefully fit the cable through the slot to the back side of the hub and
then through the guide location channel at the outside of the circular
base to exit level with the base through the channel at the back.
Your XPP Cooling Fan is now ready to stand and operate.
☆
NB - THIS IS NOT A FAULT
If the fan speed varies randomly including stopping and starting automatically you have
selected either NATURAL or NIGHTIME mode which simulate different breezy
conditions (if required). To de-select this operation please press the top right button until no
mode symbol is lit and only use the top left button to change and select the fan speed you
require (Off - Low / Med / High - Off).