Xpand RF PRO AE125-RF, User Manual

Page: 5 / 8

User Interface
Power LED
Power LED will indicate that emitter is powered and running.
Sync LED
Sync LED will not only show whether synchronization signal from projector is
present or not. User can also check the functionality of glasses looking at LED
through left or right lens; through one it should be bright, through other it should
be dim.
Push-button
Reverse Push-button is used to reverse RF sync signal. Although this can be
achieved in projector’s setting, it is more convenient to do this on emitter itself
where the user can check the picture with 3D glasses right on the spot.
Troubleshooting
Emitter is connected but 3D glasses do not work:
» Make sure power adapter is connected properly. Power LED should be lit.
» Make sure sync cable is connected properly and that projector is in 3D mode.
Sync LED should be lit.
» Make sure that your 3D glasses have been successfully paired with the emitter
and that they are turned ON. Refer to your 3D glasses’ manual for instructions
on how to pair them with new emitter.
© XPAND, All Rights Reserved. www.xpandvision.com
1
5
3
1
5