Xpand RF PRO AE125-RF, User Manual

Page: 4 / 8

© XPAND, All Rights Reserved. www.xpandvision.com
Installation
1. Connect 12VDC power adapter to AC power outlet; use one of the included
interchangeable plugs that is appropriate for your region.
2. Insert power adapter’s output plug into RF PRO’s power connector . RF PRO
will turn on automatically and will be in stand-by mode; green LED will light
up.
3. Use included sync cable to connect your projector’s 3D-VESA (MINI-DIN-3
female) sync output connector to RF PRO’s sync connector . If your projector
has a different 3D sync output connector please consult with our XPAND technical
support team.
Positioning and Mounting
»
RF PRO will emit RF sync signal omnidirectionally (meaning that it emits to all
directions), but for best performance point the front of the emitter in direction
where 3D glasses will be used.
»
Range might drop if there will be any obstacles between 3D emitter and 3D
glasses.
»
Emitter has four rubber feet so it can be securely placed on a flat surface.
»
For maximum range emitter should be raised off ground or lowered from
celling for at least 30 cm / 1 ft.
»
Emitter is equipped with mounting hole which can be used with XPAND’s
Wall Mount (sold separately). When used label should be pierced with sharp
object where it says “Mounting Hole”.
1
2
4
6