©
XPAND
, All Rights Reserved.
8
www.xpandcinema.com
©
XPAND
, All Rights Reserved.
9
www.xpandcinema.com
Storing Your XPAND 3D Glasses
It is recommended that th e glasses be stored away from any light sources
such as fluorescent lights or be covered so that unintended light does not
keep the glasses in the on-mode, thus draining the battery. Under certain
2D viewing conditions the glasses may flicker randomly if the projector is
not in 3D Sync mode. The storage temperature should be standard room
temperatures as high temperature environments can reduce battery life.
Changing the Battery
The lenses of your glasses will cease to turn on when the battery is
discharged. For the optimal viewing experience, please replace the battery
when this happens. You should only install the battery when you intend to
start using the X102 glasses.
Note:
Once the battery is installed, the touch
switch circuitry becomes active to turn the glasses on and will very slowly
consume battery life.
Step by step replacement:
Step 1
Alignment mark.
Step 2
Place the batt ery in the
receptacle and align the slott ed mark
with the arrow
Step 3
Batt ery placed - side view. Press
down on both sides of batt ery to
compress the o-ring into the cavity so
it is level and notcocked sideways.
Step 4
Batt ery tool installed under lip
of batt ery tab and placed into two
recesses in the batt ery. Should be fl at
and level.
Step 5
While holding the glasses steady,
turn the tool clockwise unti l the “c”
lines up with the alignment mark. not
turn past “c” or damage can occur!
Batt ery installati on complete.
manual-BW-4x6_FAQ-new-battery-instr-v6-2PACK.indd 8
16.11.2010 16:36:56
